| |
CorelDRAW
Versions 7,8 & 9
8
1/2 x 11 inch Assemblage Poster Construction
|
| |
| 1. |
Follow
stages 1-12 from single sheet poster creation in CorelDraw. |
| |
| 2. |
Draw
a 8 x 10 inch box (20.32 x 25.4 cm).This box represents your 81/2 x 11 inch
printed page. Copy and paste this box to break your poster up into printable
areas. |
 |
| |
| 3. |
Go
to FILE > PRINT, select your printer, paper orientation and size, then use
PRINT PREVIEW. While in the print preview screen you should see only a 81/2
x 11 inch portion of your poster. The portion of your poster centered in
your print preview screen is what will print. CLICK and DRAG with your mouse
on your poster to change what area is centered in the print preview screen.
Locate your first box and print it, then move over to the next box and print
it, continue until your entire poster has been printed. |
 |
| 4. |
Cut
each peice of paper along the grid lines of your 8 x 10 inch boxes. Lay
the individual parts of your poster face down on a table top in the correct
order. Run masking tape along the seams. You may wish to leave an extra
bit of tape at the top and bottom of your poster to use as a tag in which
to staple or pin your poster to the dispay area. If you are using spay glue
to mount your poster to foamboard in order to make it rigid, do not tim
the pages before mounting, instead wait and use an exacto knife to cut them
after they are mounted. |
| |
 |
